XDIMAX Products Forum

wow, thanks..

actually, when I openned RS tab, both checkboxes were unchecked, which most likely confused me from the beginning.
So what I had to do is enable RS (press set config) and then disables it (press set config again).

After that I'm able to control these IOs,

Thanks,

Regards,
Evgeny.

Hi, For some reasons I can't control GPIO 10 and 11. I can set them to be input or output (using sub-20 tool), but in output mode when i try to set value to 0 it automatically switches back to 1. Are they dedicated only to RS or something wrong with configuration im doing? (set Cfg to 1, Val to 0, M...

Ok, that is not a big deal, i can configure them every time I run tests.

Thank you.

Hi,

Is it possible to burn gpio configuration in controller so i don't have to initialize it every time board goes over power cicle?

Thank you.
Evgeny.