DLL translation library
Posted: Fri Sep 04, 2009 5:43 am
Here are the steps to setup SUB-20 as a replacement for obsolete U2C-12 boards
1) Install latest SUB-20 software package (see viewtopic.php?f=2&t=3)
2) Update the SUB-20 firmware to the latest one(viewtopic.php?f=2&t=31#p69 )
3) Verify that everything works properly i.e. launch subtool and try to communicate with SUB-20 board
4) Rename and unzip the attached i2cbrdg.zip.
5) Rename the original i2cbrdg.dll to i2cbrdg_orig.dll in the system32 folder
6) Copy the attached i2cbrdg.dll to the system32 folder
Run your U2C application. If during U2C_OpenDevice no SUB-20 units can be found this dll will load original i2cbrdg_orig.dll and use it for any future calls.
1) Install latest SUB-20 software package (see viewtopic.php?f=2&t=3)
2) Update the SUB-20 firmware to the latest one(viewtopic.php?f=2&t=31#p69 )
3) Verify that everything works properly i.e. launch subtool and try to communicate with SUB-20 board
4) Rename and unzip the attached i2cbrdg.zip.
5) Rename the original i2cbrdg.dll to i2cbrdg_orig.dll in the system32 folder
6) Copy the attached i2cbrdg.dll to the system32 folder
Run your U2C application. If during U2C_OpenDevice no SUB-20 units can be found this dll will load original i2cbrdg_orig.dll and use it for any future calls.