Configuring GPIO10\11
Posted: Mon Mar 10, 2014 10:42 pm
Hi,
For some reasons I can't control GPIO 10 and 11.
I can set them to be input or output (using sub-20 tool), but in output mode when i try to set value to 0 it automatically switches back to 1.
Are they dedicated only to RS or something wrong with configuration im doing?
(set Cfg to 1, Val to 0, Mask to 1 on both, Press Set Config\Write, Val switches back to '1')
Thank you.
Evgeny.
For some reasons I can't control GPIO 10 and 11.
I can set them to be input or output (using sub-20 tool), but in output mode when i try to set value to 0 it automatically switches back to 1.
Are they dedicated only to RS or something wrong with configuration im doing?
(set Cfg to 1, Val to 0, Mask to 1 on both, Press Set Config\Write, Val switches back to '1')
Thank you.
Evgeny.