Difference between revisions of "KNX"
(→KNX module installation and activation) |
|||
| Line 1: | Line 1: | ||
== KNX module installation and activation == | == KNX module installation and activation == | ||
Physical connection of CoolMasterNet to KNX bus is made with "CoolAutomation KNX extension module", further referenced as KNX module. KNX module can be pre-installed inside CoolMasterNet body by CoolAutomation or can be purchased later and installed by customer itself. Once KNX module is installed it should be activated on line L3. Run line command to check if KNX module is activated. | Physical connection of CoolMasterNet to KNX bus is made with "CoolAutomation KNX extension module", further referenced as KNX module. KNX module can be pre-installed inside CoolMasterNet body by CoolAutomation or can be purchased later and installed by customer itself. Once KNX module is installed it should be activated on line L3. Run line command to check if KNX module is activated. | ||
| − | + | {{Terminal | | |
| + | >'''line'''<br> | ||
| + | L1: DK Master U00/G00 myID:0B | ||
| + | Tx:2/2 Rx:2/2 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L2: Unused | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L3: KNX Physical Address:Not Assigned | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L4: Unused | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L5: Unused | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L6: Unused | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 | ||
| + | L7: Unused | ||
| + | Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 OK | ||
| + | }} | ||
The trace above corresponds to the activated KNX module. Otherwise special activation string should be provided. To get activation string contact CoolAutomation and specify a serial number of the CoolMasterNet device where KNX module has to be activated. | The trace above corresponds to the activated KNX module. Otherwise special activation string should be provided. To get activation string contact CoolAutomation and specify a serial number of the CoolMasterNet device where KNX module has to be activated. | ||
Revision as of 05:32, 18 April 2015
KNX module installation and activation
Physical connection of CoolMasterNet to KNX bus is made with "CoolAutomation KNX extension module", further referenced as KNX module. KNX module can be pre-installed inside CoolMasterNet body by CoolAutomation or can be purchased later and installed by customer itself. Once KNX module is installed it should be activated on line L3. Run line command to check if KNX module is activated.
|
>line |
The trace above corresponds to the activated KNX module. Otherwise special activation string should be provided. To get activation string contact CoolAutomation and specify a serial number of the CoolMasterNet device where KNX module has to be activated.
