FAQ

Networking

How to change IP address and/or other network settings

IP network configuration is made with ifconfig command described in PRM document.

Modbus RTU

How to query or change Modbus Slave Address

Modbus Slave Address is available via line command.

>line L1: SA U00/G05 myid:E5 Simul(5) Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L2: DK Slave U00/G00 myid:0B Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L3: CG5 Modbus Address:0x40(64) 9600_8N1 Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L4: Unused Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L5: Unused Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L6: Unused Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L7: LG Master U00/G00 Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 L8: Unused Tx:0/0 Rx:0/0 TO:0/0 CS:0/0 Col:0/0 NAK:0/0 OK

To change Modbus Slave Address use line command as shown below:

>line myid L3 50

This command will set Modbus Slave Address 0x50(hexadecimal)